PTT Grab ‘N’ Go Wireless Small Kit (PTTGNGS-W1)

PTT Grab ‘N’ Go Wireless Small Kit (PTTGNGS-W1A)

Beam Communications undertakes warranty and out of warranty servicing across our extensive product range.
For further information on our servicing process, warranty items and conditions please click on the button below.

Frequently Asked Questions

Signal/Connectivity

Q.My PTT handset's LED indicator is blinking

A blinking LED indicator of a wireless PTT handset can mean any of the following:

1. The handset is out of range. Bring the handset closer to the cradle (of external PTT antenna) to reestablish communication.

2. The handset has lost its pairing from the PTT cradle. Switch the handset on, also make sure the PTT cradle is switched on. Press the 2 blue volume buttons simultaneously for approximately 8 seconds until a consecutive beep is heard, then place the handset into the main PTT cradle to complete the pairing. A paired handset will have its LED continuously lit when in and outside the PTT cradle.

3. The LED only blinks when I press the PTT button and the Iridium handset does not respond to PTT button press. This is a possible hardware fault, please contact support@beamcommunications for an RMA.