How do I send remote commands to my RST100/200 or Iridium Terminal?

To configure your RST remotely you will need to know its Phone Number, and Supervisor PIN (and also the Security code if sending SSAS commands).

Remote commands are supported on RST100 and RST200 firmware 3.2 (or greater), and all RST03x firmware.

The command is constructed by using the same keyboard strokes used if you were to change the setting using the Supervisor Menu (connected to Hyper Terminal) via the Log Port @ 9600 baud.

The Complete Remote Command Guide will show you how to send remote commands to your Beam Iridium Terminal.

Download the Remote Command guide from the RST100's Common Resources tab.