Signal Logger Instructions
1. Unzip "signal_logger.zip" to a folder
2. Connect the RST100 device to your PC using the Comm Port on the RST100.
3. Power up the RST100
4. Run the file START_SIGNAL_LOGGER which is located in the extracted folder.
5. Enter in the ComPort number that the PC is using to communicate to the RST100.  This is normally "1" or "2" but if you are using a USB to Serial Port adapter it could be a higher port number.

General Information on the Program
*  The log is saved in a file called "signal_strength.log" this will be located in the same location where the zip file was uncompressed.  The time and date is sourced from your PC's clock.
*  The data is saved in Comma Delimited format which is compatible with Microsoft Excel.
*  The logger will continue to log until it is stopped.